How do I size a 2 psi natural gas line?

Q: What size gas line do I need for a 199,000 BTU tankless water heater?

For 199 MBH at 30 ft of developed length, NFPA 54 Table 6.2(1) calls for 1" Schedule 40 black iron. At 60 ft, you go to 1-1/4". Always check the tankless manufacturer's minimum gas pressure and inlet size — that often dictates pipe size more than the table.

Q: Can I use CSST for natural gas?

Yes — CSST (corrugated stainless steel tubing) is permitted by NFPA 54 when installed per the manufacturer's listing and bonded per NEC 250.104(B). CSST uses different capacity tables than black iron, so always use the manufacturer's sizing chart for the specific brand.

Q: What pressure drop does NFPA 54 allow?

For 2-PSI or less systems, 0.5" W.C. pressure drop is typical. For 2-PSI systems with a regulator at the appliance, larger drops (1.0" W.C. or 1.0 PSI on the high side) are allowed. The calculator defaults to 0.5" W.C., the most common residential design pressure drop.

Q: Where is the 2 psi natural gas pipe sizing calculator?

This is it — the gas line sizing calculator supports 2 PSI systems directly. Set the system pressure to 2 PSI and the calculator uses the matching NFPA 54 capacity tables for a two-pound residential system with a regulator at each appliance, then returns the minimum pipe size for your load and developed length.

Q: Gas pipe capacity chart for 2 psi systems

NFPA 54 publishes dedicated capacity tables for 2-PSI (2.0 psig) natural gas systems that list each nominal pipe size's maximum BTU/hr at a given developed length and allowable pressure drop (commonly 1.0 PSI). Rather than reading the chart by hand, enter your appliance load and longest run and the calculator looks up the minimum pipe size for you — then verify against your local fuel gas code.

Question

How do I size a 2 psi natural gas line?

Accepted Answer

A 2-PSI system carries gas at higher pressure from the meter, then a line-pressure regulator at each appliance drops it to the usual 0.5 PSI (about 11" W.C.). Size the 2-PSI trunk from the NFPA 54 two-pound table using total connected BTU load and the longest developed length, and size the low-pressure runs downstream of each regulator separately. Enter your loads and run length and the calculator handles both stages against the correct tables.