How long does it take to install new outdoor spigot?

This task typically takes 2-3 hours to complete, depending on your experience level and the specific conditions of your outdoor & utility plumbing system.

What tools do I need to install new outdoor spigot?

You'll need the following tools: Drill, Hole saw, Pipe cutter, Adjustable wrench. Make sure all tools are in good condition before starting.

Is this task suitable for beginners?

This task is rated as Moderate difficulty. This task requires some plumbing experience and intermediate DIY skills.

All guides

Outdoor & UtilityIntermediate

Install New Outdoor Spigot

Time

120–180 min

Steps

Pre-check

4 items

Skill

Intermediate

Scope

Install a frost-proof outdoor spigot pitched for drainage with a backflow preventer, protecting the supply line from freezing and winter burst damage.

Safety

Read before starting

Turn off main water supply; use proper tools; ensure frost-proof design; check local codes.

Pre-Check

4 items · complete before you start

Frost-proof spigot (12–18 in length) and mounting hardware
Required
Main water supply accessible and can be turned off
Required
Drill, hole saw, pipe wrenches, and soldering tools
Required
Local code requirements checked (backflow prevention)
Required

0 / 23 complete

Locate & Mark Installation

Choose location (avoid structural elements)
Mark center point
Ensure 12–18 in clearance for frost protection

✅Continue Gate:Location suitable and marked?

Turn Off Water Supply

Locate main shutoff valve
Turn off completely
Open lowest faucet to drain pressure

✅Continue Gate:Water pressure relieved?

Drill Penetration Hole

Use appropriate hole saw size
Drill from outside in
Clean up edges and debris

Install Spigot Assembly

Insert spigot through hole
Secure mounting flange
Connect to water line with proper fittings

Code notes

Frost-proof or interior shutoff with bleed required in freezing climates (IPC §305.4 / UPC §313).
Backflow protection required (IPC §608): AVB (ASSE 1001) for non-continuous-pressure or PVB (ASSE 1020) when valve is downstream of the device.

✅Continue Gate:Spigot secure and connected?

Test & Seal

Turn water back on slowly
Check for leaks at all connections
Test spigot operation
Seal penetration with appropriate caulk

✅Continue Gate:No leaks; spigot working?

Winterize & Maintain

Install freeze-proof cap
Consider backflow preventer if required
Document installation for future reference

Scope

Safety

Pre-Check

Steps

Related guides